|7mm Remington Magnum|
|Place of origin||United States|
|Designer||Remington Arms Company|
|Parent case||.375 H&H Magnum|
|Bullet diameter||.284 in (7.2 mm)|
|Neck diameter||.315 in (8.0 mm)|
|Shoulder diameter||.491 in (12.5 mm)|
|Base diameter||.512 in (13.0 mm)|
|Rim diameter||.532 in (13.5 mm)|
|Case length||2.5 in (64 mm)|
|Overall length||3.29 in (84 mm)|
|Case capacity||82.0 gr H2O (5.31 cm3)|
|Rifling twist||1/9 to 1/10"|
|Primer type||Large rifle magnum|
|Maximum pressure (C.I.P.)||62,366 psi (430.00 MPa)|
|Maximum pressure (SAAMI)||61,000 psi (420 MPa)|
|Maximum CUP||52,000 CUP|
|Test barrel length: 24"|
Source(s): Accurate Powder 
The 7mm Remington Magnum rifle cartridge was introduced as a commercially available round in 1962, along with the new Remington Model 700 bolt-action rifle. It is a member of the belted magnum family that is directly derived from the venerable .375 H&H Magnum. The original purpose of the belted magnum concept taken from the .300 H&H Magnum and .375 H&H Magnum, was to provide precise headspace control, since the sloping shoulders, while easing cartridge extraction, were unsuitable for this purpose. Improved cartridge extraction reliability is desirable while hunting dangerous game, which would be of concern when needing a fast follow up shot. The 7mm Remington Magnum is based on the commercial .264 Winchester Magnum, .338 Winchester Magnum, and .458 Winchester Magnum, which were based on the same belted .300 H&H Magnum and .375 H&H Magnum cases, trimmed to nearly the same length as the .270 Weatherby Magnum.
On its introduction, the 7mm Remington Magnum substantially usurped the market share held by the .264 Winchester Magnum, which went into sharp decline in popularity and sales after 1962. Remington has offered Managed Recoil ammunition for achieving reduced recoil when shooting and for generating less meat damage when hunting smaller game.
The 7mm Remington Magnum offers ballistics better than the .30-06 Springfield with all available bullet weights, one of the more popular loads being a 160 grain spitzer loaded to 3,000 ft/s (910 m/s). This is due both to the higher muzzle velocity of the magnum compared to the Springfield and that .284 diameter bullets tend to have better ballistic coefficients than .308 diameter bullets of comparable mass. Because of the smaller bullet diameter .284 diameter also have higher sectional density than .308 diameter bullets, and because of that better penetration in the target (it takes a 206 grain .308 diameter bullet to get the same sectional density as a 175 grain .284 bullet, an increased weight that requires 15-20% more muzzle energy to get the same muzzle velocity). The heaviest commercially loaded ammo available for the 7mm is 180 grains, while the .30-06 Springfield can be loaded with bullets up to 220 grains, but for a .308 caliber to equal the flat trajectory and penetration of a .284 diameter 180 grain bullet with a muzzle velocity of 2,860 ft/sec, as offered for the 7mm Remington Magnum, requires muzzle energy close to what the .300 Winchester Magnum can offer, i.e. well beyond what the .30-06 can deliver.
7mm Remington Magnum maximum C.I.P. cartridge dimensions. All sizes in millimeters (mm).
Americans would define the shoulder angle at alpha/2 = 25 degrees. The common rifling twist rate for this cartridge is 241 mm (1 in 9.49 in), 6 grooves, Ø lands = 7.04 mm, Ø grooves = 7.21 mm, land width = 2.79 mm. The cartridge uses a large rifle magnum primer type.
According to the official C.I.P. (Commission Internationale Permanente pour l'Epreuve des Armes à Feu Portatives) rulings, the 7mm Remington Magnum case can handle up to 430.00 MPa (62,366 psi) Pmax piezo pressure. In C.I.P. regulated countries every rifle cartridge combo has to be proofed at 125% of this maximum C.I.P. pressure to certify for sale to consumers. This means that as of 2016, 7mm Remington Magnum chambered arms in C.I.P. regulated countries are proof tested at 537.50 MPa (77,958 psi) PE piezo pressure.
Because of its flat shooting nature and the relatively tolerable recoil, the 7mm Remington Magnum is especially popular for Western plains use in the United States, as well as for use on plains game in Africa. It has also been chambered in sniper rifles as the US Secret Service counter-sniper team has deployed this cartridge in urban areas along with the .300 Winchester Magnum. Popular online gun author Chuck Hawks calls the 7mm Remington "one of the great all-around rifle cartridges."
The 7mm Winchester Short Magnum cartridge, a rebated rim bottlenecked centerfire short magnum introduced in 2001, is probably the closest ballistic twin of the 7mm Remington Magnum. The 7mm Winchester Short Magnum is considerably shorter and fatter and has a steeper shoulder angle and a shorter neck (6.17 mm) than the 7mm Remington Magnum. This makes the 7mm Remington Magnum case with its 6.89 mm long neck better suited for loading long heavier bullets. On the other hand, the proportions of 7mm Winchester Short Magnum promote good internal ballistic efficiency that allows the 7mm Winchester Short Magnum to fire shorter lighter bullets at slightly higher muzzle velocities while using less propellant than the classically proportioned 7mm Remington Magnum.
The commercially rarer 7mm Remington Short Action Ultra Magnum cartridge, a rebated rim bottlenecked centerfire short magnum introduced in 2002, is probably the other closest ballistic twin of the 7mm Remington Magnum. The 7mm Remington Short Action Ultra Magnum is considerably shorter and fatter and has a steeper shoulder angle and a longer neck (7.90 mm) than the 7mm Remington Magnum. This makes the 7mm Remington Short Action Ultra Magnum better suited for loading long heavier bullets.
These 21st century ballistic twin short fat magnum cartridges can handle 440.00 MPa (63,817 psi) Pmax piezo pressure according to the C.I.P. or a Maximum Average Pressure (MAP) of 65,000 psi (448.16 MPa) piezo pressure according to the SAAMI.
Bullet choice when reloading is critical, as bullet velocity at close ranges may result in less robust bullets disintegrating without providing significant penetration on especially tough game. Thus one would do well to use a premium bullet of some sort, for instance a bonded bullet. The choice of barrel length is also critical, as a 26-or-27-inch (660 or 686 mm) barrel is commonly needed to achieve the full velocity potential of the cartridge, and a 24 inches (610 mm) barrel should be viewed as a practical minimum. This is because in shorter, i.e., sporter, barrels, of approximately 22 inches (559 mm), the cartridge ballistics deteriorate to much the same as those achieved in a .270 Winchester, while generating more recoil and muzzle blast than the .270 Winchester.