Aircraft dope is a plasticised lacquer that is applied to fabric-covered aircraft. It tightens and stiffens fabric stretched over airframes, which renders them airtight and weatherproof, increasing their durability and lifespan. The technique has been commonly applied to both full-size and flying models of aircraft.
Doping techniques have been employed in aircraft construction since the dawn of heavier-than-air flight; the fabric of the ground-breaking Wright Flyer had benefitted from doping, as did many of the aircraft that followed soon thereafter. Without the application of dope, fabric coverings lacked durability while being highly flammable, both factors rendering them far less viable. By the 1910s, a wide variety of doping agents had entered widespread use while entirely original formulas were being regularly introduced within the industry. Typical doping agents include nitrocellulose, cellulose acetate and cellulose acetate butyrate. Liquid dopes are often highly flammable; nitrocellulose, for instance, is also known as the explosive propellant "guncotton". Dopes have often included colouring pigments to facilitate even application, and are available in a wide range of colors.
Dope has been applied to various aircraft fabrics, such as madapollam; in more recent decades, it has also been applied to polyester and other fabrics with similar fine weave and absorbent qualities. Reportedly, polyester fabric coverings have become an industry-wide standard, the use of both cotton and linen fabrics have effectively been eliminated. In addition to changes in the material that doping techniques are applied to, the methods of application have also been refined to reduce shrinking tendencies, improve adherence, and increase lifespan.
Even by the 1910s, it was recognised that, while the practice was highly beneficial, certain varieties of doping agents posed a risk to workers' health. While acetate and nitrate-based dopes were believed to pose little risk by themselves, the use of volatile compounds to dissolve them prior to application were poisonous. The medical profession across several nations became aware of this threat just prior to the First World War, and promoted the need for adequate workplace ventilation in factories where doping was performed as a mitigating measure. In the United Kingdom specifically, studies were performed into the potential health impacts of various dopes, concluding that those produced to Royal Aircraft Factory specifications rendered them less liable to result in illness than several others. Investigations into health concerns surrounding dope were also conducted during the Second World War.
As a result of increasingly powerful engines and advanced aerodynamic techniques being introduced, the use of aluminum (and subsequently composites) supplanted fabric as the primary material used throughout the aviation industry by the latter half of the twentieth century. However, various light aircraft, including gliders, home-built kits, and light sport aircraft, have continued to use fabrics and thus doping techniques continue to be employed, albeit to a lesser degree than at the dawn of aviation. Several covering methods do not make use of any dope coating processes as alternative treatment methods have been devised; however, consistency is mandated in that the same materials and techniques must be used during maintenance as had been employed in its construction, thus traditionally-built aircraft continue to use doping techniques throughout their operating lives.
Numerous accidents have occurred as a result of incorrect use of doping techniques. Examples of common mistakes include mixing it with other chemicals, its use on the wrong fabrics, or its application to contaminated or improperly prepared surfaces.
On 27 April 1995, 91-year-old aircraft designer, builder and significant figure in the homebuilt aircraft movement Steve Wittman and his wife were killed when their Wittman O&O Special broke up in flight due to delamination and separation of the wing fabric, resulting in wing aeroelastic flutter. The US National Transportation Safety Board investigation determined that the layers and types of doping that had been used on the aircraft did not have "the best adhesive qualities" and referred to "the Poly-Fiber Covering and Painting Manual" for proper processes to use.