Integrated pest management (IPM), also known as integrated pest control (IPC) is a broad-based approach that integrates practices for economic control of pests. IPM aims to suppress pest populations below the economic injury level (EIL). The UN's Food and Agriculture Organization defines IPM as "the careful consideration of all available pest control techniques and subsequent integration of appropriate measures that discourage the development of pest populations and keep pesticides and other interventions to levels that are economically justified and reduce or minimize risks to human health and the environment. IPM emphasizes the growth of a healthy crop with the least possible disruption to agro-ecosystems and encourages natural pest control mechanisms."Entomologists and ecologists have urged the adoption of IPM pest control since the 1970s. IPM allows for safer pest control.[clarification needed]
Shortly after World War II, when synthetic insecticides became widely available, entomologists in California developed the concept of "supervised insect control". Around the same time, entomologists in the US Cotton Belt were advocating a similar approach. Under this scheme, insect control was "supervised" by qualified entomologists and insecticide applications were based on conclusions reached from periodic monitoring of pest and natural-enemy populations. This was viewed as an alternative to calendar-based programs. Supervised control was based on knowledge of the ecology and analysis of projected trends in pest and natural-enemy populations.
Supervised control formed much of the conceptual basis for the "integrated control" that University of California entomologists articulated in the 1950s. Integrated control sought to identify the best mix of chemical and biological controls for a given insect pest. Chemical insecticides were to be used in the manner least disruptive to biological control. The term "integrated" was thus synonymous with "compatible." Chemical controls were to be applied only after regular monitoring indicated that a pest population had reached a level (the economic threshold) that required treatment to prevent the population from reaching a level (the economic injury level) at which economic losses would exceed the cost of the control measures.
IPM extended the concept of integrated control to all classes of pests and was expanded to include all tactics. Controls such as pesticides were to be applied as in integrated control, but these now had to be compatible with tactics for all classes of pests. Other tactics, such as host-plant resistance and cultural manipulations, became part of the IPM framework. IPM combined entomologists, plant pathologists, nematologists and weed scientists.
In the United States, IPM was formulated into national policy in February 1972 when President Richard Nixon directed federal agencies to take steps to advance the application of IPM in all relevant sectors. In 1979, President Jimmy Carter established an interagency IPM Coordinating Committee to ensure development and implementation of IPM practices.
IPM is used in agriculture, horticulture, forestry, human habitations, preventive conservation and general pest control, including structural pest management, turf pest management and ornamental pest management.
An American IPM system is designed around six basic components:
An IPM regime can be simple or sophisticated. Historically, the main focus of IPM programmes was on agricultural insect pests. Although originally developed for agricultural pest management, IPM programmes are now developed to encompass diseases, weeds and other pests that interfere with management objectives for sites such as residential and commercial structures, lawn and turf areas, and home and community gardens.
IPM is the selection and use of pest control actions that will ensure favourable economic condition, ecological and social consequences and is applicable to most agricultural, public health and amenity pest management situations. The IPM process starts with monitoring, which includes inspection and identification, followed by the establishment of economic injury levels. The economic injury levels set the economic threshold level. That is the point when pest damage (and the benefits of treating the pest) exceed the cost of treatment. This can also be an action threshold level for determining an unacceptable level that is not tied to economic injury. Action thresholds are more common in structural pest management and economic injury levels in classic agricultural pest management. An example of an action threshold is one fly in a hospital operating room is not acceptable, but one fly in a pet kennel would be acceptable. Once a threshold has been crossed by the pest population action steps need to be taken to reduce and control the pest. Integrated pest management employs a variety of actions including cultural controls such as physical barriers, biological controls such as adding and conserving natural predators and enemies of the pest, and finally chemical controls or pesticides. Reliance on knowledge, experience, observation and integration of multiple techniques makes IPM appropriate for organic farming (excluding synthetic pesticides). These may or may not include materials listed on the Organic Materials Review Institute (OMRI) Although the pesticides and particularly insecticides used in organic farming and organic gardening are generally safer than synthetic pesticides, they are not always more safe or environmentally friendly than synthetic pesticides and can cause harm. For conventional farms IPM can reduce human and environmental exposure to hazardous chemicals, and potentially lower overall costs.
Mistaken identification of a pest may result in ineffective actions. E.g., plant damage due to over-watering could be mistaken for fungal infection, since many fungal and viral infections arise under moist conditions.
Monitoring begins immediately, before the pest's activity becomes significant. Monitoring of agricultural pests includes tracking soil/planting media fertility and water quality. Overall plant health and resistance to pests is greatly influenced by pH, alkalinity, of dissolved mineral and oxygen reduction potential. Many diseases are waterborne, spread directly by irrigation water and indirectly by splashing.
Once the pest is known, knowledge of its lifecycle provides the optimal intervention points. For example, weeds reproducing from last year's seed can be prevented with mulches and pre-emergent herbicide.
Pest-tolerant crops such as soybeans may not warrant interventions unless the pests are numerous or rapidly increasing. Intervention is warranted if the expected cost of damage by the pest is more than the cost of control. Health hazards may require intervention that is not warranted by economic considerations.
Specific sites may also have varying requirements. E.g., white clover may be acceptable on the sides of a tee box on a golf course, but unacceptable in the fairway where it could confuse the field of play.
Possible interventions include mechanical/physical, cultural, biological and chemical. Mechanical/physical controls include picking pests off plants, or using netting or other material to exclude pests such as birds from grapes or rodents from structures. Cultural controls include keeping an area free of conducive conditions by removing waste or diseased plants, flooding, sanding, and the use of disease-resistant crop varieties. Biological controls are numerous. They include: conservation of natural predators or augmentation of natural predators, sterile insect technique (SIT).
Augmentation, inoculative release and inundative release are different methods of biological control that affect the target pest in different ways. Augmentative control includes the periodic introduction of predators. With inundative release, predators are collected, mass-reared and periodically released in large numbers into the pest area. This is used for an immediate reduction in host populations, generally for annual crops, but is not suitable for long run use. With inoculative release a limited number of beneficial organisms are introduced at the start of the growing season. This strategy offers long term control as the organism's progeny affect pest populations throughout the season and is common in orchards. With seasonal inoculative release the beneficials are collected, mass-reared and released seasonally to maintain the beneficial population. This is commonly used in greenhouses. In America and other western countries, inundative releases are predominant, while Asia and the eastern Europe more commonly use inoculation and occasional introductions.
The sterile insect technique (SIT) is an area-wide IPM program that introduces sterile male pests into the pest population to trick females into (unsuccessful) breeding encounters, providing a form of birth control and reducing reproduction rates. The biological controls mentioned above only appropriate in extreme cases, because in the introduction of new species, or supplementation of naturally occurring species can have detrimental ecosystem effects. Biological controls can be used to stop invasive species or pests, but they can become an introduction path for new pests.
Chemical controls include horticultural oils or the application of insecticides and herbicides. A green pest management IPM program uses pesticides derived from plants, such as botanicals, or other naturally occurring materials.
Pesticides can be classified by their modes of action. Rotating among materials with different modes of action minimizes pest resistance.
Evaluation is the process of assessing whether the intervention was effective, whether it produced unacceptable side effects, whether to continue, revise or abandon the program.
The Green Revolution of the 1960s and '70s introduced sturdier plants that could support the heavier grain loads resulting from intensive fertilizer use. Pesticide imports by 11 Southeast Asian countries grew nearly sevenfold in value between 1990 and 2010, according to FAO statistics, with disastrous results. Rice farmers become accustomed to spraying soon after planting, triggered by signs of the leaf folder moth, which appears early in the growing season. It causes only superficial damage and doesn't reduce yields. In 1986, Indonesia banned 57 pesticides and completely stopped subsidizing their use. Progress was reversed in the 2000s, when growing production capacity, particularly in China, reduced prices. Rice production in Asia more than doubled. But it left farmers believing more is better--whether it's seed, fertilizer, or pesticides.
The brown planthopper, Nilaparvata lugens, the farmers' main target, has become increasingly resistant. Since 2008, outbreaks have devastated rice harvests throughout Asia, but not in the Mekong Delta. Reduced spraying allowed natural predators to neutralize planthoppers in Vietnam. In 2010 and 2011, massive planthopper outbreaks hit 400,000 hectares of Thai rice fields, causing losses of about $64 million. The Thai government is now pushing the "no spray in the first 40 days" approach.
By contrast early spraying kills frogs, spiders, wasps and dragonflies that prey on the later-arriving and dangerous planthopper and produced resistant strains. Planthoppers now require pesticide doses 500 times greater than originally. Overuse indiscriminately kills beneficial insects and decimates bird and amphibian populations. Pesticides are suspected of harming human health and became a common means for rural Asians to commit suicide.
In 2001, scientists challenged 950 Vietnamese farmers to try IPM. In one plot, each farmer grew rice using their usual amounts of seed and fertilizer, applying pesticide as they chose. In a nearby plot, less seed and fertilizer were used and no pesticides were applied for 40 days after planting. Yields from the experimental plots was as good or better and costs were lower, generating 8% to 10% more net income. The experiment led to the "three reductions, three gains" campaign, claiming that cutting the use of seed, fertilizer and pesticide would boost yield, quality and income. Posters, leaflets, TV commercials and a 2004 radio soap opera that featured a rice farmer who gradually accepted the changes. It didn't hurt that a 2006 planthopper outbreak hit farmers using insecticides harder than those who didn't. Mekong Delta farmers cut insecticide spraying from five times per crop cycle to zero to one.
The Plant Protection Center and the International Rice Research Institute (IRRI) have been encouraging farmers to grow flowers, okra and beans on rice paddy banks, instead of stripping vegetation, as was typical. The plants attract bees and a tiny wasp that eats planthopper eggs, while the vegetables diversify farm incomes.
Agriculture companies offer bundles of pesticides with seeds and fertilizer, with incentives for volume purchases. A proposed law in Vietnam requires licensing pesticide dealers and government approval of advertisements to prevent exaggerated claims. Insecticides that target other pests, such as Scirpophaga incertulas (stem borer), the larvae of moth species that feed on rice plants allegedly yield gains of 21% with proper use.