|Pound per square inch|
|Unit system||Imperial units, US customary units|
|Unit of||Pressure, Stress|
|Symbol||psi or lbf/in2|
|SI units||6.894757 kPa|
The pound per square inch or, more accurately, pound-force per square inch (symbol: lbf/in2; abbreviation: psi) is a unit of pressure or of stress based on avoirdupois units. It is the pressure resulting from a force of one pound-force applied to an area of one square inch. In SI units, 1 psi is approximately equal to 6895 N/m2.
Pounds per square inch absolute (psia) is used to make it clear that the pressure is relative to a vacuum rather than the ambient atmospheric pressure. Since atmospheric pressure at sea level is around 14.7 psi, this will be added to any pressure reading made in air at sea level. The converse is pounds per square inch gauge (psig), indicating that the pressure is relative to atmospheric pressure. For example, a bicycle tire pumped up to 65 psig in a local atmospheric pressure at sea level (14.7 psia) will have a pressure of 79.7 psia (14.7 psi + 65 psi). When gauge pressure is referenced to something other than ambient atmospheric pressure, then the units would be pounds per square inch differential (psid).
The kilopound per square inch (ksi) is a scaled unit derived from psi, equivalent to a thousand psi (1000 lbf/in2).
The conversion in SI units is 1 ksi = 6.895 MPa, or 1 MPa = 0.145 ksi.
The conversion in SI units is 1 Mpsi = 6.895 GPa, or 1 GPa = 0.145 Mpsi.
1 lbf/in2 = (4.4482216152605 / 0.00064516) Pa
1 Pa = (0.00064516 / 4.4482216152605) lbf/in2
As the pascal is very small unit, relative to industrial pressures, the kilopascal is commonly used. 1000 kPa = 145 lbf/in2.
Approximate conversions (rounded to some arbitrary number of digits, except when denoted by "?") are shown in the following table.
|Pascal||Bar||Technical atmosphere||Standard atmosphere||Torr||Pounds per square inch|
|1 Pa||? 1 N/m2||10-5||0.000 145 037 737 730|
|1 bar||105||? 100 kPa
? 106 dyn/cm2
|14.503 773 773 022|
|1 at||? 1 kgf/cm2||0.967 841 105 354 1||735.559 240 1||14.223 343 307 120 3|
|1 atm||1||760||14.695 948 775 514 2|
|1 Torr||133.322 368 421||0.001 333 224||0.001 359 51||? 0.001 315 789||1 Torr
? 1 mmHg
|0.019 336 775|
|1 lbf/in2||6894.757 293 168||0.068 947 573||0.070 306 958||0.068 045 964||51.714 932 572||? 1 lbf/in2|
A metal's yield strength and ultimate tensile strength values are expressed in tons per square inch, pounds per square inch or thousand pounds (KSI) per square inch. For example, a tensile strength of a steel that can withstand 40,000 pounds of force per square inch may be expressed as 40,000 PSI or 40 KSI (with K being the [multiplier] for thousands of pounds). The tensile strength of steel may also be shown in MPa, or megapascal.