Get Burroughs Corporation essential facts below. View Videos or join the Burroughs Corporation discussion. Add Burroughs Corporation to your PopFlock.com topic list for future reference or share this resource on social media.
The adding machine range began with the basic, hand-cranked P100 which was only capable of adding. The design included some revolutionary features, foremost of which was the dashpot which governed the speed at which the operating lever could be pulled so allowing the mechanism to operate consistently correctly. The machine also had a full-keyboard with a separate column of keys 1 to 9 for each decade where the keys latch when pressed, with interlocking which prevented more than one key in any decade from being latched. The latching allowed the operator to quickly check that the correct number had been entered before pulling the operating lever. The numbers entered and the final total were printed on a roll of paper at the rear, so there was no danger of the operator writing down the wrong answer and there was a copy of the calculation which could be checked later if necessary. The P200 offered a subtraction capability and the P300 provided a means of keeping two separate totals. The P400 provided a moveable carriage, and the P600 and top-of-the-range P612 offered some limited programmability based upon the position of the carriage. The range was further extended by the inclusion of the "J" series which provided a single finger calculation facility, and the "c" series of both manual and electrical assisted comptometers. In the late 1960s, the Burroughs sponsored "nixi-tube" provided an electronic display calculator. Burroughs developed a range of adding machines with different capabilities, gradually increasing in their capabilities. A revolutionary adding machine was the Sensimatic, which was able to perform many business functions semi-automatically. It had a moving programmable carriage to maintain ledgers. It could store 9, 18 or 27 balances during the ledger posting operations and worked with a mechanical adder named a Crossfooter. The Sensimatic developed into the Sensitronic which could store balances on a magnetic stripe which was part of the ledger card. This balance was read into the accumulator when the card was inserted into the carriage. The Sensitronic was followed by the E1000, E2000, E3000, E4000, E6000 and the E8000, which were computer systems supporting card reader/punches and a line printer.
Later, Burroughs was selling more than adding machines, including typewriters.
Move into computers
The biggest shift in company history came in 1953: the Burroughs Adding Machine Company was renamed the Burroughs Corporation and began moving into digital computer products, initially for banking institutions. This move began with Burroughs' purchase in June 1956, of the ElectroData Corporation in Pasadena, California, a spinoff of the Consolidated Engineering Corporation which had designed test instruments and had a cooperative relationship with Caltech in Pasadena. ElectroData had built the Datatron 205 and was working on the Datatron 220. The first major computer product that came from this marriage was the B205 tube computer. In the late 1960s the L and TC series range was produced (e.g. the TC500--Terminal Computer 500) which had a golf ball printer and in the beginning a 1K (64 bit) disk memory. These were popular as branch terminals to the B5500/6500/6700 systems, and sold well in the banking sector, where they were often connected to non-Burroughs mainframes. In conjunction with these products, Burroughs also manufactured an extensive range of cheque processing equipment, normally attached as terminals to a larger system such as a B2700 or B1700.
In the 1950s, Burroughs worked with the Federal Reserve Bank on the development and computer processing of magnetic ink character recognition (MICR) especially for the processing of bank cheques. Burroughs made special MICR/OCR sorter/readers which attached to their medium systems line of computers (2700/3700/4700) and this entrenched the company in the computer side of the banking industry.
At the same time, Burroughs was very much a competitor. Like IBM, Burroughs tried to supply a complete line of products for its customers, including Burroughs-designed printers, disk drives, tape drives, computer printing paper, and even typewriter ribbons.
The Burroughs large systems machines started with the B5000 in 1961. The B5500 came a few years later when large rotating disks replaced drums as the main external memory media. These B5000 Series systems used the world's first virtual memory multi-programming operating system. They were followed by the B6500/B6700 in the later 1960s, the B7700 in the mid 1970s, and the A series in the 1980s. The underlying architecture of these machines is similar and continues today as the Unisys ClearPath MCP line of computers: stack machines designed to be programmed in an extended Algol 60. Their operating systems, called MCP (Master Control Program—the name later borrowed by the screenwriters for Tron), were programmed in ESPOL (Executive Systems Programming Oriented Language, a minor extension of ALGOL), and later in NEWP (with further extensions to ALGOL) almost a decade before Unix. The command interface developed into a compiled structured language with declarations, statements and procedures called WFL (Work Flow Language).
Many computer scientists consider these series of computers to be technologically groundbreaking. Stack oriented processors, with 48 bit word length where each word was defined as data or program contributed significantly to a secure operating environment, long before spyware and viruses affected computing. And the modularity of these large systems was also unique: multiple CPUs, multiple memory modules and multiple I/O and Data Comm processors permitted incremental and cost effective growth of system performance and reliability.
Burroughs produced the B2500 or "medium systems" computers aimed primarily at the business world. The machines were designed to execute COBOL efficiently. This included a BCD (Binary Coded Decimal) based arithmetic unit, storing and addressing the main memory using base 10 numbering instead of binary. The designation for these systems was Burroughs B2500 through B49xx, followed by Unisys V-Series V340 through V560.
The smallest general-purpose computers were the B700 "microprocessors" which were used both as stand-alone systems and as special-purpose data-communications or disk-subsystem controllers.
Burroughs also manufactured an extensive range of accounting machines including both stand-alone systems such as the Sensimatic, L500 and B80, and dedicated terminals including the TC500 and specialised check processing equipment.
Burroughs collaborated with University of Illinois on a multiprocessor architecture developing the ILLIAC IV computer in the early 1960s. The ILLIAC had up to 128 parallel processors while the B6700 & B7700 only accommodated a total of 7 CPUs and/or I/O units (the 8th unit was the memory tester).
Burroughs made military computers, such as the D825 (the "D" prefix signifying it was for defense industrial use), in its Great Valley Laboratory in Paoli, Pennsylvania. The D825 was, according to some scholars, the first true multiprocessor computer. Paoli was also home to the Defense and Space Group Marketing Division.
In 1964 Burroughs had also completed the D830 which was another variation of the D825 designed specifically for real-time applications, such as airline reservations. Burroughs designated it the B8300 after Trans World Airlines (TWA) ordered one in September 1965. A system with three instruction processors was installed at TWA's reservations center in Rockleigh, New Jersey in 1968. The system, which was called George, with an application programmed in JOVIAL, was intended to support some 4000 terminals, but the system experienced repeated crashes due to a filing system disk allocation error when operating under a large load. A fourth processor was added but did nothing to resolve the problem. The problem was resolved in late 1970 and the system became stable. Unfortunately, the decision to cancel the project was being made at the very time that the problem was resolved. TWA cancelled the project and acquired one IBM System/360 Model 75, two IBM System/360 model 65s, and IBM's PARS software for its reservations system. TWA sued Burroughs for non-fulfillment of the contract, but Burroughs counter-sued, stating that the basic system did work and that the problems were in TWA's applications software. The two companies reached an out-of-court settlement.
Burroughs developed a half-size version of the D825 called the D82, cutting the word size from 48 to 24 bits and simplifying the computer's instruction set. The D82 could have up to 32,768 words of core memory and continued the use of separate instruction and I/O processors. Burroughs sold a D82 to Air Canada to handle reservations for trips originating in Montreal and Quebec. This design was further refined and made much more compact as the D84 machine which was completed in 1965. A D84 processor/memory unit with 4096 words of memory occupied just 1.4 cubic feet (40 litres). This system was used successfully in two military projects: field test systems used to check the electronics of the Air Force General Dynamics F-111 Aardvark fighter plane and systems used to control the countdown and launch of the Army's Pershing 1 and 1a missile systems.
Merger with Sperry
In September 1986, Burroughs Corporation merged with Sperry Corporation to form Unisys. For a time, the combined company retained the Burroughs processors as the A- and V-systems lines. However, as the market for large systems shifted from proprietary architectures to common servers, the company eventually dropped the V-Series line, although customers continued to use V-series systems as of 2010[update]. As of 2017[update] Unisys continues to develop and market the A-Series, now known as ClearPath.
Burroughs Corporation RecordsCharles Babbage Institute University of Minnesota, Minneapolis. Collection contains the records of the Burroughs Corporation, and its predecessors the American Arithmometer Company and Burroughs Adding Machine Company. Materials include corporate records, photographs, films and video tapes, scrapbooks, papers of employees and the records of companies acquired by Burroughs. CBI's Burroughs Corporation Records includes over 100,000 photographs depicting the entire visual history of Burroughs from its origin as the American Arithmometer Corporation in 1886 to its merger with the Sperry Corporation to form the Unisys Corporation in 1986.
"Burroughs B 5000 Conference, OH 98", Oral history on 6 September 1985, Marina del Ray, California. Charles Babbage Institute, University of Minnesota, Minneapolis. The Burroughs 5000 computer series is discussed by individuals responsible for its development and marketing from 1957 through the 1960s in a 1985 conference sponsored by AFIPS and Burroughs Corporation.
^Anderson, J. P.; Hoffman, S. A.; Shifman, J.; Williams, R. J. (1962). "D825 - a multiple-computer system for command & control". Proceedings of the December 4-6, 1962, fall joint computer conference on - AFIPS '62 (Fall). p. 86. doi:10.1145/1461518.1461527.
^Enslow, Philip H., Jr. (1977). "Multiprocessor Organization--A Survey". Computing Surveys. 9 (1): 103-129. doi:10.1145/356683.356688.
^"Unisys Awarded Contract to Support IRS Mission-Critical Computing Systems". Unisys. 2013-02-19. Retrieved . BLUE BELL, Pa., February 19, 2013 - Unisys Corporation (NYSE: UIS) announced today that it has been awarded the Enterprise Computing Center Support (ECCS) contract from the Internal Revenue Service (IRS) [...] Under this single-award indefinite delivery-indefinite quantity (IDIQ) contract, the IRS can award Unisys task orders to provide support and maintenance services for the IRS computing environment, including Unisys ClearPath Dorado servers.